PLANET XGS3-24042 - Manual (Page 545)

34-184
show ipv6 rip database
Function:
Show messages related to RIPng database.
Command Mode:
Admin mode
Example:
Switch#show ipv6 rip database
Equal Command:
show ipv6 rip
34.25 show ipv6 rip aggregate
Command:
show ipv6 rip aggregate
Function:
To display the information of IPv6 aggregation route.
Command Mode:
Admin and Configuration Mode.
Usage Guide:
This command is used to display which interface the aggregation route be configured, Metric, Count,
Suppress and so on, if configured under global mode, then the interface display “----”. “Metric” is
metric. “Count” is the number of learned aggregation routes. “Suppress” is the times of aggregation.
Example:
To display the information of IPv6 aggregation route.
Switch(config-router)#show ipv rip agg
Aggregate information of ripng
Network Aggregated Ifname Metric Count Suppress
2001::/16 Vlan1 1 2 0
2001:1::/32 ---- 1 2 0
2001:1:2::/60 Vlan1 1 1 1
---- 1 1 1
Displayed information Explaination
Network Route prefix and prefix length.