PLANET XGS3-24042 - Manual (Page 342)

19-188
Command:
ipv6 neighbor interface
interface-number>
no ipv6 neighbor
Function:
Set static neighbor table entry.
Parameters:
Parameter ipv6-address is static neighbor IPv6 address, same to interface prefix parameter,
parameter hardware-address is static neighbor hardware address, interface-type is Ethernet type,
interface-name is Layer 2 interface name.
Command Mode:
Interface Configuration Mode
Default Situation:
There is not static neighbor table entry.
Usage Guide:
IPv6 address and multicast address for specific purpose and local address can not be set as
neighbor.
Example:
Set static neighbor 2001:1:2::4 on port E1/0/1, and the hardware MAC address is
00-30-4f-89-44-bc.
Switch(Config-if-Vlan1)#ipv6 neighbor 2001:1:2::4 00-30-4f-89-44-bc interface Ethernet 1/0/1
19.2.29 interface tunnel
Command:
interface tunnel
no interface tunnel
Function:
Create/Delete tunnel.
Parameter:
Parameter is tunnel No.
Command Mode:
Interface Configuration Mode.
Usage Guide:
This command creates a virtual tunnel interface. Since there is not information such as specific
tunnel mode and tunnel source, show ipv6 tunnel does not show the tunnel, enter tunnel mode
after creating, under that model information such as tunnel source and destination can be specified.