PLANET XGS3-24042 - Manual (Page 667)

37-306
Function:
Configure the route server client. The “no neighbor {|} route-server-client”
command cancels this configuration.
Parameter:
: Neighbor IP address
: Name of peer group
Default:
Not configured
Command Mode:
BGP route mode and address-family mode
Usage Guide:
The route service is for reducing the peers when the router between AS is too much under EBGP
environment. The server transparently transforms the routing messages to other clients with its
client exchanges messages through route server.
Example:
Three routers : 10.1.1.64（AS100） and 10.1.1.68（AS300） respectively creates neighbor
relationship with the connected 10.1.1.66（AS200）, the configuration is as follows:
Switch(config)#router bgp 200
Switch(config-router)#neighbor 10.1.1.64 remote-as 100
Switch(config-router)#neighbor 10.1.1.64 route-server-client
Switch(config-router)# neighbor 10.1.1.68 remote-as 300
Switch(config-router)# neighbor 10.1.1.68 route-server-client
37.71 neighbor send-community
Command:
neighbor {|} send-community [both|extended|standard]
no neighbor {|} send-community [both|extended|standard]
Function:
Configures whether sending the community attribute to the neighbors. The “no neighbor
{|} send-community [both|extended|standard]” command set to not
sending.
Parameter:
: IP address of the neighbor
: Name of peer group
[both|extended|standard]: Standard community only, extended community or both.
Default: