PLANET XGS3-24042 - Manual (Page 1103)

63-10
show ulpp group [group-id]
Function:
Show the configuration information of the ULPP groups which have been configured.
Parameter:
[group-id]: Show the information of the specific ULPP group.
Default:
By default, show the information of all ULPP groups which have been configured.
Command mode:
Admin mode.
Usage Guide:
Show the configuration information of ULPP groups which have been configured, such as: the state
of the master port and the slave port, the preemption mode, the preemption delay, etc.
Example:
Show the configuration information of ULPP group1.
Switch# show ulpp group 1
ULPP group 1 information:
Description: abc
Preemption mode: on
Preemption delay: 30s
Control VLAN:1
Protected VLAN: Reference Instance 1
Member Role State
--------------------------------------------------------------
Ethernet1/0/1 MASTER FORWARDING
Ethernet1/0/2 SLAVE STANDBY
63.18 ulpp control vlan
Command:
ulpp control vlan
no ulpp control vlan
Function:
Configure the receiving control VLANs of the port, the no command restores the default value.
Parameter:
specify the control VLAN list that receives the flush packets, such as: i; j-k. The number
of VLANs in Each character string can not exceed 100. The receiving control VLAN of the port can
be added.