PLANET XGS3-24042 - Manual (Page 179)

11-25
11.7 ethernet-oam errored-frame threshold high
Command:
ethernet-oam errored-frame threshold high {<high-frames> | none}
no ethernet-oam errored-frame threshold high
Function:
Configure the high threshold of errored frame event, no command restores the default value.
Parameter:
<high-frames>, the high detection threshold of errored frame event, ranging from 2 to 4294967295.
none, cancel the high threshold configuration.
Default:
none
Command Mode:
Port mode
Usage Guide:
During the specific detection period, serious link event is induced if the number of errored frame is
larger than or equal to the high threshold and the device notifies the peer by sending Information
OAMPDU of which the value of Link Fault flag in Flags field is 1. Note that the high threshold can
not be less than the low threshold.
Example:
Configure the high threshold of errored frame event on Ethernet 1/0/4 to 3000.
Switch(Config-If-Ethernet1/0/4)#ethernet-oam errored-frame threshold high 3000
11.8 ethernet-oam errored-frame threshold low
Command:
ethernet-oam errored-frame threshold low <low-frames>
no ethernet-oam errored-frame threshold low
Function:
Configure the low threshold of errored frame event, no command restores the default value.
Parameter:
<low-frames>, the low detection threshold of errored frame event, ranging from 1 to 4294967295.
Default:
1.
Command Mode:
Port mode