PLANET XGS3-24042 - Manual (Page 908)

45-53
multicast destination-control
no multicast destination-control
Function:
Configure to globally enable IPv4 and IPv6 multicast destination control, after configuring this
command, IPv4 and IPv6 multicast destination control will take effect at the same time. The no
operation of this command is to recover and disable the IPv4 and IPv6 multicast destination control
globally.
Default:
Disabled.
Command Mode:
Global Configuration Mode.
Usage Guide:
Only after globally enabling the multicast destination control, the other destination control
configuration can take effect, the destination access list can be applied to ports, VLAN-MAC and
SIP. After configuring this command, IGMP-SNOOPING, MLD-SNOOPING and IGMP, MLD will
match according to the rules mentioned above when they try to add ports after receiving
IGMP-REPORT and MLD-REPORT.
Example:
switch(config)# multicast destination-control
45.6.10 show ipv6 multicast destination-control
Command:
show ipv6 multicast destination-control [detail]
show ipv6 multicast destination-control interface [detail]
show ipv6 multicast destination-control host-address <ipv6addr> [detail]
show ipv6 multicast destination-control <vlan-id> > [detail]
Function:
Display IPv6 multicast destination control configuration.
Parameters:
detail: Whether to display detailed information.
: Interface name.
: IPv6 address.
: VLAN ID.
: MAC address.
Command Mode:
Admin Mode.