PLANET XGS3-24042 - Manual (Page 863)

45-8
Default:
Disable PIM-DM protocol
Command Mode:
Global Mode
Usage Guide:
Ipv6 pim can enable only after executing this command.
Example:
Globally enable PIM-DM protocol
Switch (config)#ipv6 pim multicast-routing
45.2.11 ipv6 pim neighbor-filter
Command:
ipv6 pim neighbor-filter cess-list-name>
no ipv6 pim neighbor-filter cess-list-name>
Function:
Configure neighbor access-list. If filtered by list and connected the neighbor, the connection
immediately was broken. If no connection, the connection can be established.
Parameter:
is an applied access-list name
Default:
No neighbor filter configuration
Command Mode:
Interface Configuration Mode
Usage Guide:
If it is not necessary for partner to establish neighbor ship, the command can filter pim message of
partner. The command can configure on IPv6 tunnel interface, but it is successful configuration to
only configure tunnel carefully.
Example:
Configure access-list of pim neighbor on interface vlan1
Switch (Config-if-Vlan1)#ipv6 pim neighbor-filter myfilter
Switch(config)#ipv6 access-list standard myfilter
Switch(config_IPv6_Std-Nacl-myfilter)#deny fe80:20e:cff:fe01:facc
Switch(config)#ipv6 access-list standard myfilter
Switch(config_IPv6_Std-Nacl-myfilter)#permit any