PLANET XGS3-24042 - Manual (Page 778)

44-53
Enable dubug information for the specified timer as requirement.
Example:
Switch#debug msdp timer
44.4.17 default-rpf-peer
Command:
default-rpf-peer [rp-policy |]
no default-rpf-peer
Function:
To configure static RPF peer.
Parameter:
: the IP address of the MSDP peer.
: the ACL number, only support standard ACL from 1 to 99.
: the standard ACL name.
Command Mode:
MSDP Configuration Mode.
Default:
There is no static RPF peer by default. If the peer command only configures one MSDP peer, this
peer will be treated as the default peer.
Usage Guide:
To configure more than one static RPF peers, make sure to use the following two configuration
methods:
Both use the rp-policy parameter: multiple RPFs take effect at the same time, and filter RP in SA
messages according to the configured prefix list, and only accept SA messages allowed to pass.
Neither uses the rp-policy parameter: according to the sequence of configuration, only the first static
RPF peer in the state of UP is active. All SA messages from this peer can be received while those
from other peers will be dropped. If the active peer loses effect (such as the configuration is
canceled or the connection is disconnected), still choose the first static RPF peer in the state of UP
in the configuration sequence to be the active static RPF peer.
Example:
Switch(config)#router msdp
Switch(router-msdp)#default-rpf-peer 10.0.0.1 rp-policy 10
44.4.18 description