PLANET XGS3-24042 - Manual (Page 628)

37-267
37.11 bgp cluster-id
Command:
bgp cluster-id {<ip-address>|<01-4294967295>}
no bgp cluster-id {[]|<0-4294967295>}
Function:
Configure the route reflection ID during the route reflection. The “no bgp cluster-id
{[]|<0-4294967295>}” command cancels this configuration.
Parameter:
|<1-4294967295>: cluster-id which is shown in dotted decimal notation or a 32 digit
number.
Default:
Not configured.
Command Mode:
BGP route mode
Usage Guide:
A cluster consists of one routing reflector and its clients in an area. However in order to increase the
redundancy level, sometime more than one routing reflectors may be deployed in one area.
Router-id is for identifying the router exclusively in an area, and cluster-id is required for two or more
reflector identification.
Example:
Configure the route reflection cluster-id is 1.1.1.1.
Switch(config-router)#bgp cluster-id 1.1.1.1
Related Command:
neighbor route-reflector-client
37.12 bgp confederation identifier
Command:
bgp confederation identifier
no bgp confederation identifier []
Function:
Create a confederation configuration. The “no bgp confederation identifier []” command
deletes a confederation.
Parameter:
: ID number of the confederation AS, ranging from 1 to 4294967295, it can be shown in