PLANET XGS3-24042 - Manual (Page 942)

47-8
No access-list configured
Usage Guide:
When the user assign specific for the first time, ACL of the serial number is created, then the
lists are added into this ACL.
Examples:
Permit tagged-eth2 with any source MAC addresses and any destination MAC addresses and the
packets whose 17th and 18th byte is 0x08, 0x0 to pass.
Switch(config)#access-list 1100 permit any-source-mac any-destination-mac tagged-eth2 16 2
0800
47.6 access-list(mac-ip extended)
Command:
access-list{deny|permit}{any-source-mac|
{host-source-mac}|{}}
{any-destination-mac|{host-destination-mac }|{}}icmp
{{}|any-source|{host-source}}
{{}|any-destination|
{host-destination}}[ []] [precedence
] [tos ][time-range]
access-list{deny|permit}{any-source-mac|
{host-source-mac}|{}}
{any-destination-mac|{host-destination-mac }|{}}igmp
{{}|any-source|{host-source}}
{{}|any-destination|
{host-destination}} [] [precedence ] [tos
][time-range]
access-list {deny|permit}{any-source-mac| {host-source-mac
}|{ }}{any-destination-mac| {host-destination-mac
}|{ }}tcp {{ }|any-source|
{host-source }}[s-port{ | range }]
{{ > } | any-destination | {host-destination
}} [d-port { | range }]
[ack+fin+psh+rst+urg+syn] [precedence ] [tos ] [time-range
]
access-list {deny|permit}{any-source-mac| {host-source-mac
}|{ <smac> }}{any-destination-mac| {host-destination-mac