PLANET XGS3-24042 - Manual (Page 1070)

60-9
Global Mode.
Default:
There is no redirection address.
Usage Guide:
Enable web portal authentication globally before configuring its HTTP redirection address. The no
command cancels the configured redirection address.
Example:
Configure the redirection address of web portal authentication as 173.16.1.211.
switch(config)#webportal redirect 173.16.1.211
Example:
Chapter 60 Commands for VRRP
60.1 advertisement-interval
Commands:
advertisement-interval <adver_interval>
no advertisement-interval
Function:
Sets the vrrp timer values; the “no advertisement-interval” command restores the default setting.
Parameters:
is the interval for sending VRRP packets in seconds, ranging from 1 to 10.
Default:
The default <adver_interva> is 1 second.
Command mode:
VRRP protocol configuration mode
Usage Guide:
The Master in a VRRP Standby cluster will send VRRP packets to member routers (or L3 Ethernet
switch) to announce its properness at a specific interval; this interval is referred to as adver_interval.
If a Backup does not receive the VRRP packets sent by the Master after a certain period (specified
by master_down_interval), then it assume the Master is no longer operating properly, therefore turns
its status to Master.