PLANET XGS3-24042 - Manual (Page 1010)

52-8
52.12 radius-server authentication host
Command:
radius-server authentication host { | <ipv6-address>} [port ]
[key ] [primary] [access-mode {dot1x | telnet}]
no radius-server authentication host { | <ipv6-address>}
Function:
Specifies the IPv4 address or IPv6 address and listening port number, cipher key, whether be
primary server or not and access mode for the RADIUS server; the no command deletes the
RADIUS authentication server.
Parameters:
| > stands for the server IPv4/IPv6 address;
<port-number> for listening port number, from 0 to 65535, where 0 stands for non-authentication
server usage;
is cipher key string;
primary for primary server. Multiple RADIUS Sever can be configured and would be available.
RADIUS Server will be searched by the configured order if primary is not configured, otherwise, the
specified RADIUS server will be used last.
[access-mode {dot1x|telnet}] designates the current RADIUS server only use 802.1x
authentication or telnet authentication, all services can use current RADIUS server by default.
Command mode:
Global Mode
Default:
No RADIUS authentication server is configured by default.
Usage Guide:
This command is used to specify the IPv4 address or IPv6 address and port number, cipher key
string and access mode of the specified RADIUS server for switch authentication, multiple
command instances can be configured. The port parameter is used to specify authentication port
number, which must be the same as the specified authentication port in the RADIUS server, the
default port number is 1812. If this port number is set to 0, the specified server is regard as
non-authenticating. This command can be used repeatedly to configure multiple RADIUS servers
communicating with the switch, the configured order is used as the priority for the switch
authentication server. When the first server has responded (whether the authentication is
successed or failed), switch does not send the authentication request to the next. If primary is
specified, then the specified RADIUS server will be the primary server. It will use the cipher key
which be configured by radius-server key global command if the current RADIUS server
not configure key. Besides, it can designate the current RADIUS server only use 802.1x
authentication or telnet authentication via access-mode option. It is not configure access-mode