4 show monitor, Show monitor – PLANET XGS3-24042 User Manual
Page 1114
65-6
throughput of the interfaces to be mirrored. If the destination of a session is removed, the mirror
path configured in the session will be removed at the same time. And if the destination interface is
reconfigured, the interface path will be recovered. To be mentioned, the flow mirror can only be
recovered after the destination of the interface is re-configured.
Example:
Configure interface 1/0/7 as the destination of the mirror.
Switch(config)#monitor session 1 destination interface ethernet 1/0/7
65.4 show monitor
Command:
show monitor
Function:
To display information about the source and destination ports of all the mirror sessions.
Command Mode:
Admin Mode
Usage Guide:
This command is used to display the source and destination ports for the configured mirror sessions.
For port mirroring and flow mirroring, the mirror mode of the source can be displayed. For MAC
mirroring, MAC mirror configuration will be displayed for the supported switch cards.
Example:
Switch#show monitor