Echelon LonMaker - Manual (Page 64)

48 Getting Started
Tips:
• You can click Finish at any point in the Network Wizard. Doing so will skip the subsequent
series of pages, and your new LonMaker network design will be created using the current
settings in the New Network Options tab of the LonMaker Design Manager.
• By default, the subsequent pages in the Network Wizard will appear each time you re-open
the LonMaker drawing. Select the Skip This Prompt when Re-opening this Drawing check
box on any of the pages you want to skip when re-opening the drawing.
• You can change any options you set in the Network Wizard in the LonMaker drawing. Open
the LonMaker menu, click Network Properties, and then click the tab containing the
options you want to modify.
5. Edit the following information as required:
Network Name Displays the network name. By default, this is the current name in
the Network Name box under New Network in the General tab of
the LonMaker Design Manager. The default network name is
incremented if a naming conflict exists.
You can change the name of the network. The name must be unique
to the network database, and it can have a maximum of 14
characters. The network name in the Network Database Path and
Network Drawing Path fields will automatically be updated to
match the name you specify.
Recover Database
from Network Opens the LNS Database Recovery Wizard after completing the
Network Wizard. You can use the recovery wizard to create a new
LonMaker drawing and network database from an existing
operational network.
See Recovering a LonMaker Network in Chapter 7, Maintaining
Networks, for more information.