Echelon LonMaker User Manual

Page 141

LonMaker User’s Guide

125

The connector shape and its reference shape will both be hidden on that end. Repeat this step on
the other attached functional block to hide the corresponding shapes on the other end of the
connection.

The following series of figures demonstrates how you can hide and show connections. This example
uses two analog input functional blocks connected to an analog functional block. One connector shape
is attached directly to both functional blocks; the other is attached via a reference shape.

Show Connectors is set by default on all three functional blocks.

Right click AI- 1.AI- 1, point to Display Options, and then click Hide Connectors. There is no
change because Show Connectors is still set on functional block A1-1.AFB-1.

Right click A1-1.A1-2, point to Display Options, and then click Hide Connectors. The connector
and reference shapes attached to this functional block are hidden. There is no change to the connector
and reference shapes attached to A1-1.AFB-1 because connector shapes attached via reference are
hidden/shown independently on each end.

Connectors Hidden