Echelon LonMaker - Manual (Page 61)

LonMaker User’s Guide 45
LonMaker Default Options
You can use the LonMaker Default Options tab to set the LonMaker default properties for the new
networks you create. This tab contains a list of LonMaker options categories such as options for
devices, functional blocks, and configuration properties. The default options you set will be applied to
each new LonMaker network you create. Once you create a new network, you can change any of the
default options in the LonMaker drawing by opening the LonMaker menu and clicking LonMaker
Options.
Click Restore Defaults to reset the options and values in the currently displayed options category to
their defaults.
You can set the default options for new networks in the following options categories:
• Backup/Restore
• Configuration Properties
• Device
• Functional Blocks
• General
• LNS Event Options
• LonMaker Font
• Naming Options
• Network Explorer
• NV Browser/Monitoring
• Recovery
• Service Pin
• Shape ToolTips
• Synchronization
• Warnings
Appendix A details the defaults you can set under each network properties options category.