Echelon LonMaker - Manual (Page 58)

42 Getting Started
New Network Options
You can use the New Network Options tab to set the default properties for the network interface,
plug-ins, user logon, and management mode pages in the Network Wizard, and set the default network
components. The properties you set are then applied to each new network you create.
You can also select options to have the LonMaker tool skip the pages in the Network Wizard when
opening a network. If you additionally clear the Show all Options check box under the New Network
box in the General tab, you can create new networks with one-click, skipping all the pages in the
Network Wizard.
The LonMaker Design Manager’s New Network Options tab contains the following options:
Network Interface
Network Attached Select this check box to specify that the LonMaker computer will be
attached to the physical network so that the LonMaker tool can
communicate with the physical devices.
Clear this check box if you the LonMaker computer will not be
attached to the network. This check box is cleared by default.
Network Interface
Name Select the LNS network interface to be used for communication
between the LonMaker computer and the physical network. This
option is only available if you selected the Network Attached check
box.
Skip Network Interface
Options Page Skips the network interface page in the Network Wizard when you
create a new LonMaker network.
Plug-Ins
Register Plug-Ins Select this check box to register all enabled plug-ins when you create
a new LonMaker network.