Echelon LonMaker - Manual (Page 327)

LonMaker User’s Guide 311
device’s location string. By default, the location string is
initialized to all zeroes unless you enable the Set Location
Property to Subsystem ID check box in the network properties:
Recovery options category.
NewAdvPropCap • Specifies handling of the advanced properties dialog in the
new device wizard.
• A value of 0 specifies that the advanced properties dialog is
not to be displayed.
• A value of 1 indicates that the advanced properties dialog is
to be displayed, but cannot be modified.
• A value of 2 indicates that the advanced properties dialog is
displayed and changes can be made.
• The default value is 0 (the advanced properties dialog is not
displayed).
NewPropCap • Specifies handling of the basic properties dialog in the new
device wizard.
• A value of 0 specifies that the basic properties dialog is not to
be displayed.
• A value of 1 indicates that the basic properties dialog is to be
displayed, but cannot be modified.
• A value of 2 indicates that the basic properties dialog is
displayed and changes can be made.
• The default value is 2 (the basic properties dialog is displayed
and changes are allowed).
NonGrpRcvTimer Specifies the default non-group receive timer; a value of -1
indicates that the LNS default value will be used. Otherwise, the
value is encoded as follows:
Encoded
Value Seconds
0 0.016
1 0.024
2 0.032
3 0.048
4 0.064
5 0.096
6 0.128
7 0.192
8 0.256
9 0.384
10 0.512
11 0.768
12 1.024
13 1.536
14 2.048
15 3.072