Dell POWEREDGE M1000E User Manual
Page 963
Fabric OS Command Reference
931
53-1001764-02
switchShow
2
No_Sync
The module is receiving light but is out of sync.
In_Sync
The module is receiving light and in sync.
Laser_Flt
The module is signaling a laser fault.
Port_Flt
The port is marked faulty.
Diag_Flt
The port failed diagnostics.
Lock_Ref
The port is locking to the reference signal.
Testing
The port is running diagnostics.
Offline
A port connection is not established (for virtual ports only).
Online
The port is up and running.
Proto
Protocol support by GbE port.
ISCSI
The ports supports ISCSI.
FCIP
The port supports FCIP.
FCoE
The port supports Fibre Channel over Ethernet.
comment
Optionally displays one of the following:
Copper or Optical
Displays which GbE port is currently active: Copper indicates that the RJ45
GbE port is currently active. Only copper connections are accepted (default).
Optical indicates that the currently active GbE port accepts both copper and
optical connections (SFPs). This parameter is set by the portCfgGeMediaType
command, and applies only to the ge0 and ge1 ports on the Brocade 7800.
Disabled
The port is disabled.
Bypassed
The port is bypassed (loop only).
Loopback
The port is in loopback mode.
E_Port
Fabric port; displays the world wide name (WWN) and name of the attached
switch. If the port is configured as an EX_Port, the WWN of the attached
switch is the same as the router.
F_Port
Point-to-point port; displays the WWN of the attached N_Port. If that specific
F_Port receives 1 FDISK frame, switchShow displays the total number of NPIV
Public ports as 1, for example: F_Port 1 NPort + 1 NPIV devices.
G_Port
Point-to-point port, but not yet E_Port or F_Port.
L_Port
Loop port; displays the number of NL_Ports.
EX_Port
Router port; displays the WWN of the attached edge switch.
VF_Port
FCoE Virtual F_Port. For these ports, the number of NPIV or external device
logins is displayed ("n VN-Port(s)"), instead of the WWN of the internal port.
Mirror Port
The port is a mirror port.
(Trunk master) The port is the master port in a group of trunking ports.
(Trunk port, master is port #x)
The port is configured as a trunking port; the master port is port #x.
(upstream)
The E_Port is an upstream path toward the principal switch of the fabric.