Dell POWEREDGE M1000E - Manual (Page 55)

Fabric OS Command Reference 23
53-1001764-02
ag
2
auto Enables the automatic port configuration policy. When enabled, this policy
applies to all ports on the switch. All F_Port to N_Port mapping and port group
configurations are ignored.
ads Enables the advanced device security (ADS) policy. When enabled, this policy
applies to all the ports on the switch. By default all devices have access to the
fabric on all ports.
wwnloadbalance
Enables the device WWN load balancing policy. When this policy is enabled,
device logins are sent to the least loaded port in the port group to which they
are mapped. These devices are displayed with ag --wwnmapshow as
dynamic device mappings. Port Group policy must be enabled before you can
enable the WWN load balancing policy.
--
policydisable policy
Disables the specified policy for the Access Gateway. When a policy is
disabled, all port-related configuration settings are lost. Use the configUpload
command to save the current port configuration. Valid policies are:
pg Disables the port grouping policy. All port group configurations are deleted.
Disabling port grouping policy enables the Get Fabric Name policy.
auto Disables the automatic port configuration policy and deletes all associated
configuration settings.
ads Disables the advanced device security (ADS) policy and deletes all lists of
allowed device WWNs.
wwnloadbalance
Disables the device WWN load balancing policy.
--
mapshow [N_Port | device_WWN]
Displays the F_Ports that are configured and currently mapped to a given
“primary” N_Port. Optionally specify an N_Port to display the F_Ports that are
mapped to the specified N_Port only, or specify a device WWN to display the
N_Port to which the device WWN is mapped. Failover and failback policies are
displayed as enabled (1) or disabled (0).
--
mapset N_Port [F_Port1; F_Port2;...]
Maps a set of F_Ports to a specified “primary” N_Port forcing all traffic from
the F_Ports to be routed through this N_Port to the attached fabric. An F_Port
cannot be mapped to more than one primary N_Port at any given time.
F_Ports are enabled only if the N_Port is online. This command overwrites
existing port mappings. Use a blank list ("") to clear current mappings.
--
mapadd N_Port F_Port1 [; F_Port2;...]
Adds one or more specified F_Ports to the mapping of an existing “primary”
N_Port. The traffic for the configured F_Ports is routed to the fabric through
the specified N_Port when the F_Ports come online. An F_Port cannot be
mapped to more than one primary N_Port at the same time.
--
mapdel N_Port F_Port1 [; F_Port2;...]
Deletes one or more specified F_Ports from the “primary” N_Port mapping.