Dell POWEREDGE M1000E - Manual (Page 25)

Fabric OS Command Reference xxv
53-1001764-02
FCIP
• portCfg - Updated for IPv6, advanced compression, and DSCP configuration support. Minimum
committed rate has changed from 1,544 kbps to 10000 Kbps. Keep Alive default is now 1000
ms.
• portCfgShow - Updated for IPv6 configuration support
• portShow - Updated to display new portCfg options and values.
FCping
• fcPing - New options to support SuperPing. Not supported on FCR.
FICON
• ficonCfg - Refer to New Commands.
• ficonCupSet - New CRP operand to set the current reporting path.
• ficonCupShow - New LP operand to display logical paths on the switch.
• ficonShow - New flags to distinguish LIRR entry types (current or secondary)
Lossless DLS
Ability to configure Lossless has moved from iodSet to dlsSet. You can no longer configure lossless
with the iodSet command. Refer to the section “Deprecated Commands” section (Lossless DLS) for
changes made to iodSet.
• dlsShow - Enhanced to display Lossless configuration
• dlsSet - Configures Lossless.
Platform support
• switchShow - Updated for mini-FSP support.
• sfpShow - Updated for mini-FSP support.
• slotshow - Updated for new hardware.
Port configuration
• portCfgEport - New mode value 2 to lock down port as E_Port.
• portstats64show - Now displays one 64-bit number, SNMP counters.
• portSwapShow - Now displays 24-bit port Address (PID) instead of area.
• portSwap - Now displays 24-bit port Address (PID) instead of area.
The following commands have been enhanced to support port ranges and port index ranges: