Dell POWEREDGE M1000E - Manual (Page 644)

612 Fabric OS Command Reference
53-1001764-02
portCfg
2
portCfg
Manages port configuration parameters for FC ports, VE_ports, and GbE/10GbE ports.
Synopsis portcfg action [slot/] port arguments
portcfg action [slot/] ge_port arguments
portcfg action [slot/]ve_port options arguments
portcfg action [slot/][ge_port options arguments
Description Use this command to manage port configuration parameters on FC ports as well as on Gigabit
Ethernet (GbE) ports on the Brocade 7800/FX8-24 and on the Brocade 7500/7500E/FR4-18i.
This command has been modified to support the configuration of FCIP tunnels on the Brocade
7800/FX8-24 platforms. As a result, the behavior of this command in Fabric OS v6.3.0 and later
has changed.
You must use this command in a manner that honors the platform-specific differences in
command syntax and behavior. Some command options are not available on all platforms. Others
behave differently depending on the platform on which they are executed.
Platform specific commands are documented in separate sections that include function, synopsis,
description, operands and examples. Use the following section headings to navigate this page.
• “Commands supported on all platforms”
- portcfg mirrorport - Configure a mirror port on the local FC port.
- portcfg rscnsupr - Manage registered state change notification (RSCN) suppression on the
local port.
• “Commands supported on the Brocade 7800/FX8-24 and the Brocade 7500/7500E/FR4-18i
platforms”
- portcfg ipif - Configure the local IP interfaces
- portcfg iproute - Configure a static route on the IP interface.
- portcfg vlantag - Manage the IP interface VLAN configuration for FCIP.
• “Commands supported only on the Brocade 7800 and the Brocade FX8-24 platforms”
- portcfg fciptunnel - Create, modify, and delete Fibre Channel over IP (FCIP) tunnels
(although this command is technically valid on the Brocade 7500/7500E/FR4-18i
platforms as well, the behavior is very different, and the command is therefore described
separately for each platform).
- portcfg fcipcircuit - Create, modify, and delete FCIP circuits.
• “Commands supported only on the Brocade 7500/7500E and the Brocade FR4-18i platforms”
- portcfg arp - Add and delete address resolution protocol (ARP) entries. Flush ARP table.
- portcfg fciptunnel - Create, modify, and delete Fibre Channel over IP (FCIP) tunnels (FCIP)
tunnels (although this command is technically valid on the Brocade 7800/FX8-24
platforms as well, the behavior is very different, and the command is therefore described
separately for each platform).
- portcfg fastwrite - Configure the FC port for FC FastWrite.
- portcfg ficon - Manage FICON emulation in an FCIP tunnel.