Dell POWEREDGE M1000E - Manual (Page 540)

508 Fabric OS Command Reference
53-1001764-02
msConfigure
2
msConfigure
Configures the Management Server (MS) access control list (ACL).
Synopsis msconfigure
Description Use this command to configure the MS Access Control List (ACL). The MS allows a Storage Area
Network (SAN) management application to retrieve and administer the fabric and Interconnect
Elements, such as switches. This application is located at the Fibre Channel well-known address,
0xFFFFFA.
If the MS ACL is empty (default), The MS is available to all systems connected to the fabric. By
populating the MS ACL with one or more world wide names (WWNs), you can restrict access to MS
to the specified WWNs.
This command is interactive and provides the following choices:
0 Done
1 Display the access list
2 Add member based on its port/node WWN
3 Delete member based on its port/node WWN
When changing the MS ACL by adding or deleting WWNs, you are prompted to save the new
configuration to nonvolatile storage. The saved MS ACL becomes effective upon reboot.
The MS ACL is implemented on a per-switch basis and should be configured on the switch to which
the management application is directly connected.
Notes When an FCS policy is enabled, the MS ACL is not used. In such a case, access to MS is controlled
by security by way of the MS_POLICY configuration.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
This command is supported only in AD0 and AD255 contexts.
Operands none
Examples To display the MS ACL:
switch:admin>
msconfigure
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1]
1
MS Access List consists of (5): {
20:01:00:60:69:00:60:10
20:02:00:60:69:00:60:10
20:03:00:60:69:00:60:10
20:02:00:60:69:00:60:03
20:02:00:60:69:00:60:15