Dell POWEREDGE M1000E - Manual (Page 659)

Fabric OS Command Reference 627
53-1001764-02
portCfg
2
To set the compression rate to ‘moderate’ on the tunnel:
switch:admin>
portcfg fciptunnel 1/12 modify -c 2
Operation succeeded
To enable and configure FICON emulation on the tunnel:
switch:admin>
portcfg fciptunnel 1/12 modify -F 1 --ficon -xrc 1
Operation succeeded
To configure FCIP FastWrite and Tape Pipelining on the tunnel:
switch:admin>
portcfg fciptunnel 1/12 modify -f 1 -t 1
Operation succeeded
To delete circuit 1:
switch:admin> portcfg fcipcircuit 1/12 delete 1
Operation succeeded
To configure VLAN tagging on a tunnel:
1. Create a tunnel with VLAN tagging set.
switch:admin>
portcfg fciptunnel 16 create 192.168.2.20 192.168.2.10 100000 -v 100
Operation Succeeded
2. Create a circuit with VLAN tagging set.
switch:admin>
portcfg fcipcircuit 16 create 1 192.168.2.21 192.168.2.11 100000 -v 200
Operation Succeeded
3. Modify an existing circuit to change the VLAN tag and L2 CoS levels.
switch:admin>
portcfg fcipcircuit 16 modify 0 -v 300 --l2cos-f 7 --l2cos-h 5 --l2cos-m 3 --l2cos-l 1
!!!! WARNING !!!!
Modify operation can disrupt the traffic on the fcipcircuit specified for a
brief period of time. This operation will bring the existing circuit down (if
circuit is up) before applying new configuration.
Continue with Modification (Y,y,N,n): [ n]
y
Operation Succeeded
4. Modify existing circuit to change DSCP marking values
switch:admin>
portcfg fcipcircuit 16 modify 0 --dscp-f 32 --dscp-h 16 --dscp-m 8 --dscp-l 4
Operation Succeeded
5. Display the tunnel configuration and circuit values.
switch:admin>
portshow fciptunnel 16 -c
-------------------------------------------
Tunnel ID: 16
Tunnel Description:
Admin Status: Enabled
Oper Status: In Progress
Compression: Off
Fastwrite: Off
Tape Acceleration: Off
TPerf Option: Off
IPSec: Disabled
Remote WWN: Not Configured
Local WWN: 10:00:00:05:1e:c3:f0:16