Dell POWEREDGE M1000E User Manual
Page 211
Fabric OS Command Reference
179
53-1001764-02
cryptoCfg
2
crypto_target_container_name
Displays information for the specified CryptoTarget container. If the -stat
parameter is specified with this operand, the CTC must be hosted on the local
node.
-cfg
Displays the configuration for the specified CTC.
-stat
Displays the runtime status for the specified CTC.
--
show -tapepool
Displays configuration information for specified tape pools when used with
the -cfg option. Displays runtime status information for specified tape pools
when used with the -cfg option. This command is valid on all nodes. The
following operands are supported:
-all -cfg
Displays configuration information for all configured tape pools in the
encryption group.
-all -stat
Displays runtime status information for all configured tape pools in the
encryption group.
-label pool_label | -num pool_num
Displays tape pool configuration or runtime status information for a single
tape pool specified either by a tape pool label or a number. These operands
must be used with either the -stat or the -cfg option.
-cfg | -stat
Displays either configuration information or runtime status for the
specified tape pools.
--
show -LUN
Displays Crypto LUN configuration or runtime status information for a
specified CTC. This command is valid on all nodes. The following operands
are supported:
crypto_target_container_name
Specifies the CTC for which to display the Crypto LUN information.
LUN_Num
Specifies the number of the LUN for which to display information.
initiator_PWWN Specifies the PWWN of the initiator.
-cfg | -stat
Displays either the configuration or the status of the specified Crypto LUN.
The configuration can be displayed on any node in the encryption group. To
display LUN status, the specified LUN must be hosted on the local node.
--
show -rekey
Displays information about rekey sessions in progress. This command is valid
on all nodes. The following operands are mutually exclusive:
-all
Lists all rekey sessions in progress on the current node.
crypto_target_container_name
Lists all rekey sessions in progress for a specified CryptoTarget container. You
may further specify either one of the following operands:
LUN_Num
Lists all rekey sessions in progress for a specific Crypto LUN of the
specified CryptoTarget container.
initiator_PWWN Lists all rekey sessions in progress for a specific initiator of the specified
CryptoTarget container.
--
show -tape_sessions
Displays runtime tape session information. This command is valid on all
nodes. The following operands are mutually exclusive: