Dell POWEREDGE M1000E - Manual (Page 569)

Fabric OS Command Reference 537
53-1001764-02
nsZoneMember
2
nsZoneMember
Displays the information on online devices zoned with a specified device.
Synopsis nszonemember pid | wwn
nszonemember -a | -u
Description Use this command to display information on all online devices zoned with the specified device. The
device can be specified by WWN or Port ID (PID). Use this command with the -u option to display all
unzoned devices in the entire fabric. Use the -a option to display online zoned device data for each
local device.
The command output displays the following information:
Type U - known, N - N_Port, NL - NL_Port.
Pid The 24-bit Fibre Channel address.
COS A list of classes of service supported by the device.
PortName The device's port world wide name (WWN).
NodeName The device's node WWN.
Permanent Port Name
The physical N_Port or NL_Port WWN.
DeviceType The device type.
Port Index The index of the port to which the device is attached.
Shared Area Whether or not the device shares an area with other devices.
Device Shared in Other AD
Whether or not the device is shared in other Admin Domains.
Additional lines may display if the device has registered any of the following information (the switch
automatically registers SCSI inquiry data for FCP target devices):
• FC4 supported
• IP address (node)
• IPA
• port and node symbolic name (local device only)
• fabric port name
• hard address or port IP address
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
PID | WWN Specifies the port ID or WWN of the device for which to display zoned devices.
-a Displays each local device’s online zoned device data, including the device
PID and zone alias.