Dell POWEREDGE M1000E User Manual
Page 809
Fabric OS Command Reference
777
53-1001764-02
portShow
2
To display the connection IPSec information on an FCIP tunnel on a GbE port:
switch:admin>
portshow fciptunnel 9/ge0 0 -ipsec
Slot: 9 Port: ge0
-------------------------------------------
Tunnel ID 0
Tunnel Description "This is a test Description of this tunnel"
Remote IP Addr 10.62.0.100
Local IP Addr 10.10.9.100
Remote WWN Not Configured
Local WWN 10:00:00:05:1e:39:d4:5a
Compression on
Fastwrite on
Tape Pipelining on
Uncommitted bandwidth, minimum of 1000 Kbps (0.001000 Gbps)
SACK on
Min Retransmit Time 100
Keepalive Timeout 90
Max Retransmissions 9
VC QoS Mapping off
DSCP Marking (Control): 10, DSCP Marking (Data): 62
VLAN Tagging Id 1062, L2CoS (Control): 1, L2CoS (data): 0
TCP Byte Streaming on
Status : Active
Connected Count: 1
Uptime 2 hours, 13 minutes, 58 seconds
IKE Policy 1
-----------------------------------------
Authentication Algorithm: SHA-1
Encryption: AES-128
Perfect Forward Secrecy: on
Diffie-Hellman Group: 14
SA Life (seconds): 28800
IPSec Policy 1
-----------------------------------------
Authentication Algorithm: SHA-1
Encryption: AES-128
SA Life (seconds): 28800
Pre-Shared Key testingFIPSandIPSec
To display the TCIP connection history after the connection was severed:
Switch:admin>
portshow fciptunnel ge1 0 -hist
Port: ge1
-------------------------------------------
Tunnel ID 0
Tunnel Description "This is a test Description of this tunnel"
Remote IP Addr 192.168.114.2
Local IP Addr 192.168.114.1
Remote WWN Not Configured
Local WWN 10:00:00:05:1e:38:84:65
Compression off
Fastwrite off
Tape Pipelining off
Committed Rate 900000 Kbps (0.900000 Gbps)
SACK on
Min Retransmit Time 100
Keepalive Timeout 10