Dell POWEREDGE M1000E - Manual (Page 817)

Fabric OS Command Reference 785
53-1001764-02
portStats64Show
2
swConnUnittStatRxMulticastToObjects, stat_mc_to
The number of multicast timeouts.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
This command is not supported on FCoE ports.
Operands This command has the following operands:
slot For bladed systems only, specify the slot number of the port to be displayed,
followed by a slash (/).
port Specify a port number to be displayed, relative to its slot for bladed systems.
Use switchShow to display a list of valid ports.
-long Displays the counters as one single 64-bit number. This operand is optional;
if omitted, the lower and upper 32-bits are reported as two separate
numbers.
Examples To display the 64-bit hardware statistics for a port:
switch:user>
portstats64show 4/15
stat64_wtx 0 top_int : 4-byte words transmitted
316 bottom_int : 4-byte words transmitted
stat64_wrx 0 top_int : 4-byte words received
1486 bottom_int : 4-byte words receive
stat64_ftx 0 top_int : Frames transmitted
69 bottom_int : Frames transmitted
stat64_frx 0 top_int : Frames received
73 bottom_int : Frames received
stat64_c2_frx 0 top_int : Class 2 frames received
0 bottom_int : Class 2 frames received
stat64_c3_frx 0 top_int : Class 3 frames received
37 bottom_int : Class 3 frames received
stat64_lc_rx 0 top_int : Link control frames received
8 bottom_int : Link control frames received
stat64_mc_rx 0 top_int : Multicast frames received
0 bottom_int : Multicast frames received
stat64_mc_to 0 top_int : Multicast timeouts
0 bottom_int : Multicast timeouts
stat64_mc_tx 0 top_int : Multicast frames transmitted
0 bottom_int : Multicast frames transmitted
tim64_rdy_pri 0 top_int : Time R_RDY high priority
60438254 bottom_int : Time R_RDY high priority
tim64_txcrd_z 0 top_int : Time BB_credit zero
2 bottom_int : Time BB_credit zero
er64_enc_in 0 top_int : Encoding errors inside of frames
0 bottom_int : Encoding errors inside of frames
er64_crc 0 top_int : Frames with CRC errors
0 bottom_int : Frames with CRC errors
er64_trunc 0 top_int : Frames shorter than minimum
0 bottom_int : Frames shorter than minimum
er64_toolong 0 top_int : Frames longer than maximum
0 bottom_int : Frames longer than maximum
er_bad_eof 0 top_int : Frames with bad end-of-frame