Dell POWEREDGE M1000E User Manual

Page 204

172

Fabric OS Command Reference

53-1001764-02

cryptoCfg

initiator_NWWN Specifies the initiator node WWN.

delete -container

Deletes a specified CTC. This command removes the virtual target and
associated LUNs from the fabric. Before issuing this command, you must stop
all traffic to the target port for which the CTC is being deleted. Failure to do so
results in I/O failure between the initiators and that target Port.

This command is valid only on the group leader. The following operand is
required when deleting a CTC:

crypto_target_container_name

Specifies the name of the CTC to be deleted. Use cryptocfg --show
-container for a listing of valid CTC names.

failback -EE

Performs a manual failback of all CTCs that were failed over earlier to another
encryption engine within an HA cluster to a "new" specified encryption engine.
This command generates an error if the specified current encryption engine
and new encryption engine are not members of the same HA cluster or if the
current encryption engine or the new encryption engine are offline.

This command is valid only on the group leader. The following operands are
required:

current_node_WWN [current_slot]

Specifies the node WWN of the current encryption engine to which failover
occurred earlier, and which is now performing all encryption tasks. On bladed
systems, specify the slot number of the current encryption engine.

new_node_WWN [new_slot]

Specifies the node WWN of the encryption engine to which failback of all
CTCs should occur. On bladed systems, specify the slot number of the new
encryption engine.

move -container Moves the specified CTC from its currently configured encryption engine to

another encryption engine. This command is valid only on the group leader.
The EEs must be part of the same encryption group for this operation to
succeed, but they do not need to be part of the same HA cluster. This
operation permanently changes the encryption engine association of a single
CTC from an existing encryption engine to another encryption engine. To
move all CTCs hosted on an encryption engine permanently to another
encryption engine, use cryptocfg --replace .

This command is valid only on the group leader. The following operands are
required when moving a CTC:

crypto_target_container_name

Specifies the name of the CTC to be moved.

new_node_WWN [new_slot]

Specifies the encryption engine to which the CTC should be moved. On
bladed systems, specify the encryption engine’s slot number.

add -initiator

Adds one or more initiators to an existing CTC. An initiator that is added to a
CTC facilitates discovering the LUNs of the target as exposed to these
initiators. You must still add the initiators when you add the LUN to the CTC to
enable access for these initiators.