Fcoe – Dell POWEREDGE M1000E User Manual

Page 287

Fabric OS Command Reference

255

53-1001764-02

FCoE

Manages and displays FCoE configuration.

Synopsis

fcoe --cfgshow [[slot]port]

fcoe --disable [slot]port

fcoe --enable [slot]port

fcoe --loginshow [[slot]port]

fcoe --fcmapset -vlan vid fcmapid

fcoe --fcmapunset -vlan vid

fcoe --fipcfg -advintvl intvl

fcoe --fipcfgshow

fcoe --resetlogin [-teport slot/port | -device wwn ]

fcoe --help

Description

Use this command to configure and display the status of FCoE ports, FCoE Initialization Protocol
(FIP), and FCMAP settings.

Unlike regular FC ports, FCoE ports are embedded interfaces that are not directly associated with
an external physical port on the switch. Although show commands such as switchShow display
FCoE ports as “ports,” configuration of these ports through the regular FC CLI is disabled. Only the
FCoE CLI commands can be used.

Note

The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.

Operands

This command has the following operands.

slot

Specifies the slot number on bladed systems, followed by a slash (/).

port

Specifies the port number. There are 24 configurable embedded FCoE ports
on the Brocade 8000 switch, and the valid range for port is 8 to 31. On the
Brocade FCoE 10-24 blade, there are 24 configurable FCoE ports numbered
0-23. Use switchShow for a list of valid FCoE ports.

help

Displays the command usage.

cfgshow

Displays the configuration of a specified embedded FCoE port. If a port is not
specified, the command displays all port configurations.

disable

Disables the specified FCoE port.

enable

Enables the specified FCoE port.

loginshow

Displays information about the devices logged into the specified FCoE port.

fcmapset

Configures the FCMAP values for Fabric Provided MAC Addresses (FPMA) for
the specified VLANs.

-vlan vid

Specifies the VLAN for which to set the FCMAP.

fcmapid

Specifies the FCMAP to be set.