Dell POWEREDGE M1000E - Manual (Page 917)

Fabric OS Command Reference 885
53-1001764-02
snmpConfig
2
-
mib_name mib_name
Specifies the name of the MIB to be configured. This operand is required if
you want to configure MIB traps noninteractively. Valid MIB names include
the following.
• FE-MIB
• SW-MIB
• FA-MIB
• FICON-MIB
• HA-MIB
• FCIP-MIB
• ISCSI-MIB
• IF-MIB
• BD-MIB
-bitmask bit_mask
Specifies the bit mask for the MIB. In Fabric OS v6.4.0 and later, SNMP Traps
are identified by their bit mask and can be read directly from the switch
configuration. The MIB and trap status (enabled or disabled) status is
recorded in a 64- bit counter. The last bit (bit 0) is reserved for the MIB and
the remaining bits are reserved for the traps of that MIB. The trap's position is
allocated based on the last ID of the trap OID. For example, the last ID of the
swEventTrap is 5 so its position will be 5th from the right. Refer to
Table 25
for a listing of valid bit masks.
TABLE 25 SNMP Trap bit mask values
MIB Trap Name Bit mask Default
FE-MIB (Fibre Channel FE evants) 0x1 Enabled
SW-MIB (switch events) 0x1 Enabled
swFault 0x2 Enabled
swSensorScn 0x4 Enabled
swFCPortScn 0x8 Enabled
swEventTrap 0x10 Enabled
swFabricWatchTrap 0x20 Enabled
swTrackChangeTraps 0x40 Enabled
swIPv6ChangeTrap 0x80 Enabled
swPmgrEventTrap 0x100 Enabled
swFabricSegmentTrap 0x200 Disabled
swFabricReconfigTrap 0x400 Disabled
swExtTrap 0x800 Disabled
FA-MIB (fabric events) 0x1 Enabled
connUnitStatusChange(1) 0x2 Enabled
connUnitAddedTrap (2) N/A Enabled
connUnitDeletedTrap (3) 0x8 Enabled
connUnitEventTrap (4) 0x10 Enabled