Dell POWEREDGE M1000E - Manual (Page 205)

Fabric OS Command Reference 173
53-1001764-02
cryptoCfg
2
This command is valid only on the group leader. The following operands are
required when adding an initiator to a CTC:
crypto_target_container_name
Specifies the name of the CTC to which the initiators should be added.
initiator_PWWN Specifies the initiator port WWN.
initiator_NWWN Specifies the initiator node WWN.
--
remove -initiator
Removes an initiator from the specified CTC. This command is valid only on
the group leader. The following operands are required when removing an
initiator:
crypto_target_container_name
Specifies the name of the CTC fro which the initiator is to be removed.
initiator_PWWN
Specifies the initiator port WWN.
--
add -LUN Adds a LUN to a CTC and optionally sets encryption policies for the LUN. The
maximum number of Tape LUNs that can be added to an Initiator in a
container is 8. LUN policies may be set at this time or after the LUN is added.
The maximum number of LUNs you can add in one commit operation is 25.
There is a delay of five seconds for each commit operation.
This command is valid only on the group leader. The following operands are
supported:
crypto_target_container_name
Specifies the name of the CTC to which the LUN is added. This operand is
required.
LUN_Num | LUN_Num_Range
Specifies the LUN number or a range of LUN numbers. These operands are
mutually exclusive. The LUN number can be either a 16-bit (2 bytes) number
in hex notation (for example, 0x07) or a 64-bit (8 bytes) number in WWN
format (for example, 00:07:00:00:00:00:00:00). When specifying a range,
the LUN numbers must be 16-bit numbers in hex format. The Range
parameter is not supported for 64-bit LUN numbers.
The LUN number must be zero when a tape LUN is specified and the tape
drive is a single LUN device.
initiator_PWWN initiator NWWN
Optionally specifies one or more hosts (initiators) that will be permitted to
access the LUN. For each initiator added, the port WWN and the node WWN
must be specified. You may add more than one initiator.
Encryption policy parameters: The following encryption policy configuration parameters can be
optionally set for disk and tape devices when adding a LUN to a CTC, or they can be set at a
later time with the --modify -LUN command.
The tape policies specified at the LUN level take effect if you do not create tape pools or
configure policies at the tape pool level.