Dell POWEREDGE M1000E - Manual (Page 910)

878 Fabric OS Command Reference
53-1001764-02
slotShow
2
Status Displays the status of the blade as one of the following:
VACANT The slot is empty.
INSERTED, NOT POWERED ON
The blade is present in the slot but is turned off.
POWERING UP The blade is present and powering on.
LOADING The blade is present, powered on, and loading the initial configuration.
DIAG RUNNING POST1
The blade is present, powered on, and running the POST (power-on self-test).
DIAG RUNNING POST2
The blade is present, powered on, and running the preboot power on self
tests.
INITIALIZING The blade is present, powered on, and initializing hardware components.
ENABLED The blade is on and fully enabled.
ENABLED (SAS Virtualization Disabled)
The blade is on, but due to an incompatibility between the FOS image and the
SAS or Application image, the SAS Virtualization services are disabled. Only
applies to the FA4-18 blade.
DISABLED The blade is powered on but disabled.
FAULTY The blade is faulty because an error was detected.
UNKNOWN The blade is inserted but its state cannot be determined.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS Commands" and Appendix A, "Command
Availability" for details.
Operands This command supports the following operands:
-p In addition to the basic slot status view, displays the following information
about power consumption:
• Total direct current (DC) power consumption for the chassis and
individual values for each blade (in Watts). Note that usage for other
components is included but not listed.
• Total alternating current (AC) power consumption in Watts.
• AC efficiency, as a percentage of total and BTU.
• Power efficiency in Watts/port and Watts/Gb.
-m In addition to the basic slot status view, displays the Brocade model name for
each blade.