Dell POWEREDGE M1000E - Manual (Page 578)

546 Fabric OS Command Reference
53-1001764-02
passwdCfg
2
-sequence value
Specifies the length of sequential character sequences that will be
disallowed. A sequential character sequence is defined as a character
sequence in which the ASCII value of each contiguous character differs by
one. The ASCII value for the characters in the sequence must all be
increasing or all decreasing. For example, if the "sequence" value is set to 3, a
password "passABCword" is disallowed because it contains the sequence
"ABC". A password of "passABword" would be allowed because no repeated
character sequence exceeds two characters. The range of allowed values is
1-40. The default value is 1.
--
disableadminlockout
Disables the admin lockout policy if already enabled and sets the config
parameter "passwdcfg.adminlockout" to 0. By default, admin lockout policy is
disabled.
--
setdefault Resets all password policies to their default values.
--
help Displays the command usage.
Examples To display the current password configuration parameters:
switch:admin>
passwdcfg
--
showall
passwdcfg.minlength: 8
passwdcfg.lowercase: 0
passwdcfg.uppercase: 0
passwdcfg.digits: 0
passwdcfg.punctuation: 0
passwdcfg.history: 1
passwdcfg.minpasswordage: 0
passwdcfg.maxpasswordage: 0
passwdcfg.warning: 0
passwdcfg.lockoutthreshold: 0
passwdcfg.lockoutduration: 30
passwdcfg.status: 0
To set passwd configuration parameters, specifying that a password must contain at least two
uppercase characters, and that passwords expire in 90 days from the date they are defined:
switch:admin>
passwdcfg --set -uppercase 2 -maxpasswordage 90
Diagnostics The passwdCfg command may fail for any of the following reasons:
Permission failure
You not permitted to execute the command.
Invalid command line option
An unrecognized command line option was specified.
minlength value out of range
The -minlength value must be between 8 and 40.