Dell POWEREDGE M1000E User Manual
Page 349
Fabric OS Command Reference
317
53-1001764-02
ficonCupSet
2
CRP PID CHID
Sets the current reporting path (CRP). The reporting path is a CUP
mechanism for sending FRU-failure reports to a FICON logical path via FICON
protocol. The logical path between the PID and the CHID must exist and be in
operational state for this command to succeed. Use ficonCupShow with the
LP option to display the logical paths on the switch. The following operands
are required:
PID
Specifies the Port identifier.
CHID
Specifies the Channel ID (CHID). The CHID is the Logical Partition (LPAR)
identifier supplied as part of the FICON protocol header. The format of the
CHID is a numerical identifier followed by a letter, for example, 1B.
Examples
To enable FMS mode for the switch:
switch:admin>
ficoncupset fmsmode enable
fmsmode for the switch is now Enabled
To set the ASM bit in the mode register for the switch:
switch:admin>
ficoncupset modereg ASM 1
Active=Saved Mode bit is set to 1
To set the MIHPTO value to 60 seconds:
switch:admin>
ficoncupset MIHPTO 60
MIHPTO has been changed to 60 seconds
To set the current reporting path:
switch:admin>
ficoncupset CRP 082300 1A
To display the current reporting path:
switch:admin>
ficoncupshow LP
FICON CUP Logical Paths for CUP 0x08FE00
LP Reporting
PID CHID State Path
------ ---- ---- ------
082300 1A Oper*** Curr
082300 1B Oper
082300 1C Oper
082400 1A Reset
082400 1B Reset
612400 1E Reset Prim
612400 1F Reset
See Also
ficonCupShow