Fanshow – Dell POWEREDGE M1000E User Manual
Page 275

Fabric OS Command Reference
243
53-1001764-02
fanShow
2
fanShow
Displays fan status and speed.
Synopsis
fanshow
Description
Use this command to display the current status and speed of each fan in the system.
Fan status is displayed as:
OK
Fan is functioning correctly.
absent
Fan is not present.
below minimum
Fan is present but rotating too slowly or stopped.
above minimum
Fan is rotating too quickly.
unknown
Unknown fan unit installed.
faulty
Fan has exceeded hardware tolerance and has stopped. In this case, the last
known fan speed is displayed.
The output from this command varies depending on switch type and number of fans present.
Note
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands
none
Examples
To display information on the fans in the system:
switch:admin>
fanshow
Fan #1 is OK, speed is 2721 RPM
Fan #2 is OK, speed is 2657 RPM
Fan #3 is OK, speed is 2700 RPM
See Also
chassisShow, fanDisable, fanEnable, psShow