Fcipchiptest – Dell POWEREDGE M1000E User Manual
Page 280

248
Fabric OS Command Reference
53-1001764-02
fcipChipTest
2
fcipChipTest
Tests functionality of components in the FCIP complex.
Synopsis
fcipchiptest [--slot slot][-testtype type][-unit number]
Description
Use this command to verify the internal registers and memory of the network processor, FCIP FPGA,
compression processor, and GigPHY.
Notes
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
This command is supported only on Brocade FR4-18i blades and Brocade 7500 platforms.
Operands
This command has the following operands:
--
slot slot
Specifies the slot number on which the diagnostic operates. The default is 0
and operates on fixed-port-count products.
-testtype type
Specifies the test type to run. By default, the command runs all tests. Valid
tests include:
0
All tests
1
Network processor SRAM test
2
FCIP FPGA internal register test
3
FCIP FPGA interrupt test
4
FCIP FPGA checksum test
5
Compression engine MBIST and LBIST
-unit number
Specifies the GbE port to test. By default, all GbE ports in the specified slot
are used. Valid number values include:
0
GbE port 0
1
GbE port 1
2
All GbE ports
Examples
To run all tests on slot 7 and GbE port 1:
switch:admin>
fcipchiptest
--
slot 7 -unit 1 -testtype 0
Running fcipchiptest ..............
Test Complete: fcipchiptest Pass 1 of 1
Duration 0 hr, 1 min & 15 sec (0:1:15:351).
passed.