Dell POWEREDGE M1000E - Manual (Page 1009)

Fabric OS Command Reference 977
53-1001764-02
trunkDebug
2
trunkDebug
Debugs a trunk link failure.
Synopsis trunkdebug port1 port2
Description Use this command to debug a trunk link failure. This command reports one of the following
messages, based on the trunking properties of the two specified ports:
• Switch does not support trunking
• Trunking license required
• Trunking not supported in switch interop mode
• port port_id is not E_Port
• port port_id trunking disabled
• port port_id speed is not 2G, 4G or 8G
• port port_id and port port_id are not in same port group
• port port_id and port port_id connect to different switches
• port port_id and port port_id connect to the switch WWN
• port port_id is not a trunking port due to: E_Port being disabled, or trunking might be disabled
at remote port
• port port_id and port port_id cannot trunk, please check link length to make sure difference is
less than 400 m
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
port1 Specify the port index number of port 1. Use the switchShow command to
view the index numbers for a port. This operand is required.
port2 Specify the port index number of port 2. Use the switchShow command to
view the index numbers for a port. This operand is required.
Examples To debug a trunk connection:
switch:admin>
trunkdebug 43 44
Switch does not support trunking
switch:admin>
trunkdebug 62 63
port 62 and 63 are trunked together
See Also portCfgTrunkPort, switchCfgTrunk, trunkShow