Portcfgshow – Dell POWEREDGE M1000E User Manual
Page 706
674
Fabric OS Command Reference
53-1001764-02
portCfgShow
2
portCfgShow
Displays port configuration settings.
Synopsis
portcfgshow
portcfgshow [slot/]port
portcfgshow -i [index1[-index2] [...] [-f]]
portcfgshow -slot slot1[-slot2] [...]
portcfgshow option [slot/][ge_port] [arguments] [optional_arguments]
Description
Use this command to display the current configuration of a port. The behavior of this command is
platform-specific; output varies depending on port type and platform, and not all options are
supported on all platforms.
When used without operands, this command displays port configuration settings for all ports on a
switch, except Gigabit Ethernet (GbE) ports.
Use this command with optional arguments to display the following parameters configured for a
GbE port on the Brocade 7800/FX8-24 and on the Brocade 7500/7500E/FR4-18i platforms.
•
IP interfaces on the GbE port
•
Static routes on the IP interfaces
•
Address resolution protocol (ARP) entries
•
VLAN tag configuration
•
Fibre Channel over IP (FCIP) tunnel configuration settings
-
IPSec configuration
-
QoS mappings (Brocade 7500/7500E/FR4-18i only)
“Displays supported only on the Brocade 7500/7500E/FR4-18i platforms”
•
Port mode information
•
Inband Management IP addresses and routes (Brocade 7500 only)
Non-GbE port displays
The following information is displayed when the command is issued for all ports, for a single port, or
for one or more port ranges specified by their port index numbers or slot numbers:
Area Number
Displays the port area number. This field is displayed only when portCfgShow
is executed for a single port.
Speed
Displays Auto for auto speed negotiation mode, or a specific speed of 1, 2, 4,
or 8 Gbps. This value is set by the portCfgSpeed command.
Fill Word
Displays one of the following numeric values: 0(Idle-Idle), 1(arbff-arbff),
2(Idle-arbff), or 3(A-A then SW I-A).This parameter is set by the portcfgFillword
command.