Dell POWEREDGE M1000E User Manual
Page 262

230
Fabric OS Command Reference
53-1001764-02
fabPortShow
2
0x00000800
Zoning has completed
0x00001000
Segmented by Platform Management
0x00002000
Segmented due to no license
0x00004000
Segmented due to E_Port disabling
0x00008000
DIA already sent for that port
0x00010000
RDI already sent
0x00020000
Port is true T port
0x00040000
Port received an ELP
0x00080000
Port received an ELP RJT
0x00100000
LR pending due to ELP RJT rcv
0x00200000
Received a DIA on this port
0x00400000
Port is the EMT Initiator
0x00800000
Security violation
0x01000000
Security incompatibility
0x02000000
Rcv a DIA ACC
0x040000000 Port is security authenticating
0x080000000 ECP RJT or retires exceeded
0x100000000 Segmented due to duplicated WWN
0x200000000 Segmented due to E_Port isolation
0x40000000 ELP complete on loopback port
0x80000000 Logical E_Port corresponding to physical EX_PPort
nbrWWN
Neighboring switch WWN
nbrPort
Neighboring switch port
lr_tid
Link reset timer identifier and current state
flow_control
The flow control mode of the link.
nghbr_escF
Lists info exchanged by the neighbor switch in ESC (link level protocol). Values
for etiz_state can be as follows:
-1 Unknown
ETIZ
state
2
ETIZ capable but not configured
3
ETIZ capable and configured
red_ports
All E_Ports that are connected to the same neighboring switch
Note
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.