Dell POWEREDGE M1000E - Manual (Page 679)

Fabric OS Command Reference 647
53-1001764-02
portCfgEXPort
2
an error message is posted, and the command fails. Valid values are as
follows:
0 Brocade Native mode.
1 McDATA Open Fabric mode.
2 McDATA Fabric mode.
3 MCDATA fabric legacy mode.
Note that this mapping between mode values and modes is NOT the same as
the mapping used when setting interoperability modes with the interopMode,
command.
-i mode Enables or disables Insistent Domain Id (IDID) for the specified EX_Port.
Specify 1 to enable IDID, specify 2 to disable IDID. This command must be
issued from a McDATA edge switch attached to a single or dual FCR
configuration.
Examples To set the fabric ID of port 2/1 to 5 and the port ID format to core:
switch:admin>
portcfgexport 2/1 -f 5 -p 1
To configure port 2/0 to be an EX_Port and set the fabric ID to 4:
switch:admin> portcfgexport 2/0 -a 1 -f 4
To disable fabric parameter negotiation on port 2/0 of an EX_Port:
switch:admin>
portcfgexport 2/0 -t 2
To enable IDID on port 2:
switch:admin>
portcfgexport 2 –i 1
To display EX_Port settings configured for Mi10K connectivity:
switch:admin> portcfgexport 10
Port 10 info
Admin: enabled
State: OK
Pid format: Not Applicable
Operate mode: Open
Domain Id mode: 239 Mode
Insistent Domain ID Mode: enabled
Front WWN: 50:00:51:e3:76:0e:4e:46
Fabric Parameters: Auto Negotiate
R_A_TOV: Not Applicable
E_D_TOV: Not Applicable
Authentication Type: None
DH Group: N/A
Hash Algorithm: N/A
Edge fabric's primary wwn: N/A
Edge fabric's version stamp: N/A
See Also portCfgVEXPort, portDisable, portEnable, portShow, portCfgDefault, fcrbCastConfig