Dell POWEREDGE M1000E - Manual (Page 181)

Fabric OS Command Reference 149
53-1001764-02
cryptoCfg
2
host_username
Specifies the user name for the host. Depending on your host
configuration, this command may prompt for a password.
host_file_path Specifies the fully qualified path of the file to be imported. The path must
include the file name.
-usb Imports a file from a mounted USB storage device. This command is valid
only on nodes with an attached USB device. When -usb is specified, the
following operands are required:
dest_filename Specifies the name to be assigned to the imported file. This is a
user-generated file name.
source_filename
Specifies the name of the certificate on the USB storage device from
which you are importing.
--
reg -membernode
Registers a member node with the group leader. This command is valid only
on the group leader. The encryption group must have been created prior to
performing member node registration. All member nodes and group leaders
must be registered before encryption group discovery and formation can
occur.
The order in which member node registration is performed defines group
leader succession. At any given time, there is only one active group leader in
an encryption group. The group leader succession list Specifies the order in
which group leadership is assumed if the current group leader is not
available.
The following operands are required when registering a member node with
the group leader:
member_node_WWN
Specifies the switch world wide name of the member node.
member_node_certfile
Specifies the member node CP certificate. You must have exported this file
earlier to external storage and then imported it to the group leader before you
can register a member node. Use cryptocfg --show -file -all to view all
imported certificates.
member_node_IP_addr
Specifies the IP address of the member node to be registered with the group
leader.
--
dereg -membernode
Removes the registration for the specified member node. This command is
valid only on the group leader. The node is identified by the switch WWN.
member_node_WWN
Specifies the member node by its switch WWN. This operand is required
when removing a node registration.