Dell POWEREDGE M1000E - Manual (Page 458)

426 Fabric OS Command Reference
53-1001764-02
ipAddrShow
2
• stateless - Acquired through stateless autoconfiguration.
IP Address state:
• tentative
• preferred
• deprecated
Refer to the RFC 2462 specification for more information.
On modular platforms with intelligent blades, the addresses configured for each slot can be shown
with the -slot option. On standalone platforms, all command options are ignored.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
-cp cp_number On dual-CP systems, specifies the CP card number to be displayed (0 or 1).
-chassis On dual-CP systems, displays the IP addresses for the chassis.
-slot slot Specifies the slot for a blade.
-eth0 |-eth1 |-gate For a specified slot, shows only the selected Ethernet interface or the gateway
. This operand is optional with the -slot option.
Examples To display the IP addresses on a standalone switch:
switch:admin>
ipaddrshow
SWITCH
Ethernet IP Address: 192.168.163.238
Ethernet Subnetmask: 255.255.255.0
Gateway IP Address: 192.168.163.1
DHCP: Off
IPv6 Autoconfiguration Enabled: No
Local IPv6 Addresses:
static 1080::8:800:200c:417a/64
To display all IP addresses on a Brocade DCX backbone:
switch:admin>
ipaddrshow
Chassis
Ethernet IP Address: 10.33.60.85
Ethernet Subnetmask: 255.255.240.0
CP0
Ethernet IP Address: 10.33.60.86
Ethernet Subnetmask: 255.255.240.0
Host Name: cp0
Gateway IP Address: 10.33.48.1
CP1
Ethernet IP Address: 10.33.60.87
Ethernet Subnetmask: 255.255.240.0
Host Name: cp1
Gateway IP Address: 10.33.48.1