Dell POWEREDGE M1000E - Manual (Page 678)

646 Fabric OS Command Reference
53-1001764-02
portCfgEXPort
2
If the Fabric Parameter value is “Auto Negotiate”, the port ID format, R_A_TOV, and E_D_TOV values
display the negotiated values indicated by “(N)” next to them. The negotiated values are what the
edge switch specifies in the ELP request. If the state is “Not OK”, the R_A_TOV and E_D_TOV
display “Not Applicable”. By default, all EX_Ports are auto-ELP enabled.
If the Fabric Parameter attribute value is “User configured”, the port ID format R_A_TOV and
E_D_TOV values display the configured values.
A configuration change that would result in an invalid domain ID for McDATA Open Fabric mode or
McDATA Fabric mode causes the preferred domain ID to be set to the minimum valid McDATA mode
domain ID of 1. The exception to this is if the configuration change includes setting the preferred
domain ID, in which case the configuration change does not take place and a corresponding error
message is displayed.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands When invoked without operands, this command displays the usage. The following operands are
supported:
slot On bladed systems only, specifies the slot number followed by a slash (/).
port Specifies the por number. Use switchShow for a list of valid ports. When
executed with [slot]port only, the command displays the current port
configuration.
-a admin Enables or disables the specified port as an EX_Port. Valid values are 1
(enable as EX_Port), 2 (disable as EX_Port and enable as non-EX_Port).
portCfgDefault may also be used to disable EX_Ports.
-f fabricid Specifies the fabric ID. Valid values are 1-128.
-r ratov Specifies the R_A_TOV used for port negotiation. Valid values are 2000 -
120000. This operand is only applicable if the "Fabric Parameter" attribute
value is not "Auto Negotiate".
-e edtov Specifies the E_D_TOV used for port negotiation. Valid values are 1000 -
60000. This operand is only applicable if the "Fabric Parameter" attribute
value is not "Auto Negotiate".
-d domainid Specifies the preferred domain ID. For Brocade native mode (-m 0) or McDATA
Open Fabric mode (-m 1), valid values are 1-239. Use 239 for connectivity
with the Mi10k director. For McDATA Fabric mode (-m 2), valid values are
1-31.
-p pidformat Specifies the Port ID format. Valid values are 0-native, 1-core, 2-extended
edge. This operand is applicable only when port mode is set to 0 (native
mode). If port mode is not "Brocade Native", the Port ID format displays as
"Not applicable".
-t fabric_parameter Enables or disables negotiation of the fabric parameters. Valid values are 1
for enable and 2 for disable.
-m port mode Specifies the port mode. The -m option enforces the same port mode for all
the ports connected to the same edge fabric. If this option is selected, the
port mode is compared against the online ports. If the modes are different,