Dell POWEREDGE M1000E User Manual
Page 646
614
Fabric OS Command Reference
53-1001764-02
portCfg
2
The syntax for portCfg mirrorport is as follows:
portcfg mirrorport [slot/]port mode
Valid modes for mirrorport are:
--
disable
Disables the configuration. When disabled, a port cannot be a mirror port.
--
enable
Enables the configuration. When the mirror port feature is enabled to a port,
a mirror connection can use this port to mirror traffic.
Examples
To enable a mirror port configuration:
switch:admin>
portcfg mirrorport 2/4
--
enable
Please confirm enable of Mirror Port (Y,y,N,n): [n] y
To configure a range of ports as RSCN-suppressed:
switch:admin>
portcfg rscnsupr 2/4-7 --enable
Function
Commands supported on the Brocade 7800/FX8-24 and the Brocade 7500/7500E/FR4-18i
platforms
Synopsis
portcfg action [slot/] ge_port arguments
Description
Use this command to configure the local IP interfaces and static routes on the Brocade
7800/FX8-24 and on the Brocade 7500/7500E/FR4-18i platforms. You must configure the local
IP interfaces before you can create and configure FCIP tunnels. In Fabric OS v6.3.1 and later, you
can also create a VLAN configuration at the IP interface on the Brocade 7800/FX8-24. The
configuration procedures described in this section are essentially the same.
•
portcfg ipif - Configure the local IP interfaces.
•
portcfg iproute - Configure a static route on the IP interface.
•
portcfg vlantag - Manage the IP interface VLAN configuration for FCIP.
Operands
This command has the following operands:
slot
For bladed systems only, specifies the slot number of the port to be
configured, followed by a slash (/).
ge_port
Specifies the number of the GbE port to be configured. The GbE ports are
numbered ge0 - ge9 on the Brocade FX8-24 blade and ge0 - ge5 on the
Brocade 7800 switch. The two 10GbE ports on the Brocade FX8-24 blade are
numbered xge0 and xge1. The two GbE ports on the Brocade 7500/7500E,
and FR4-18i are numbered ge0 and ge1. Use the switchShow command for a
list of valid ports.
ipif
Defines the IP interface for both ports of a tunnel.
On the Brocade 7800 and FX8-24, up to eight IP interfaces per GbE port are
supported, but only 4 FCIP circuits can be configured on a single GbE port. Up
to 10 IP interfaces and 10 FCIP circuits are supported on the 10GbE port.
On the Brocade 7500/7500E/FR4-18i, up to eight IP interfaces per GbE port
are supported.
The IP network connection is configured by defining IP interfaces for origin
and destination virtual ports, and then defining one or more IP routes to
connect them. The syntax for portCfg ipif is as follows: