Dell POWEREDGE M1000E User Manual
Page 824
792
Fabric OS Command Reference
53-1001764-02
portStatsShow
2
ip_err_tcp_data_chksum
The number of IP TCP data checksum errors observed on the GbE port.
Note
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
This command is not supported on FCoE ports.
Operands
This command has the following operands:
slot
For bladed systems only, specifies the slot number of the port to be displayed,
followed by a slash (/).
[ge]port
Displays statistics for a single port identified by the port number, relative to
its slot on bladed systems. Specify the optional ge option to display the GbE
port hardware statistics. Port ranges are not supported with this command.
Use switchShow for a listing of valid ports.
-i index1[-index2]
Displays statistics for a single port or for a range of ports identified by port
index numbers. You may specify multiple index ranges separated by a space,
for example, -i 33-47 65-73.
-f
Ignores nonexisting ports. This operand is valid only with the -i option.
-slot] [slot1[-slot2]
Displays statistics for all ports on a slot or on a range of slots, for example, -s
3-5. You may specify multiple slot ranges separated by a space, for example,
-s 3-5 8-10.
ge
Displays the GbE port statistics.
ip
Displays all GbE port statistics related to IP addresses that are not zero. This
operand is not supported on the Brocade 7800 and FX8-24 platforms.
ip_address
Specifies an IP address to display statistics only for the specified IP address.
This operand is optional and valid only with the ip option.
fcip
Displays the GbE statistics on all FCIP tunnels. This operand is not supported
on the Brocade 7800 and FX8-24 platforms.
tunnel_number Specifies a tunnel ID to display statistics only for the specified FCIP tunnel.
This operand is optional and valid only with the fcip option.
-h
Displays the command usage.
Examples
To display the basic set of statistics for port 1/13 on a DCX backbone:
switch:admin>
portstatsshow 13
stat_wtx 0 4-byte words transmitted
stat_wrx 0 4-byte words received
stat_ftx 0 Frames transmitted
stat_frx 0 Frames received
stat_c2_frx 0 Class 2 frames received
stat_c3_frx 0 Class 3 frames received
stat_lc_rx 0 Link control frames received
stat_mc_rx 0 Multicast frames received
stat_mc_to 0 Multicast timeouts
stat_mc_tx 0 Multicast frames transmitted
tim_rdy_pri 0 Time R_RDY high priority
tim_txcrd_z 0 Time TX Credit Zero (2.5Us ticks)