Dell POWEREDGE M1000E User Manual

Page 454

422

Fabric OS Command Reference

53-1001764-02

ipAddrSet

-ipv6 [-auto | -noauto]

Enables or disables stateless IPv6 autoconfiguration on a switch or chassis.
When autoconfiguration is enabled, the host automatically performs
configuration of IPv6 addresses and periodic nondisruptive reconfiguration.
By default, autoconfiguration is disabled.

-ls FID

Specifies the logical fabric ID for which to configure an IPFC network
interface. The FID is a decimal number. A switch that is not in Virtual Fabric
mode uses the -ls parameter with FID 128 (the effective, single Logical Fabric
number on such switches) to set the IPv4 FC address. Note that setting the
IP address for the logical switch is only for the IPFC interface, not for the
Ethernet interface.

add

Assigns a specified IPv4 FC address and prefix to the logical switch instance
represented by the specified FID. This command replaces any existing FC
IPv4 address.

IPv4_address/prefix

Specifies the IPv4 address and prefix for the IPFC network interface. The
IP Address is represented by a dotted decimal number, followed by a
slash and a prefix. This operand is required with the --add option.

delete

Deletes the IPv4 FC address and prefix from a logical switch.

-ls IFID

Specifies the fabric ID that identifies the logical switch for which to delete
the FC IPv4 address and prefix. This operand is required when deleting
an FC IPv4 address from a logical switch. On a switch that is not in Virtual
Fabric mode, use the -ls parameter with FID 128 (the effective, single
Logical Fabric number on such switches) to delete the IPv4 FC address.

When used interactively to configure IPv4 addresses on a modular platform, ipAddrSet prompts for
the following parameters:

-cp cp_number

Specifies the managed entity as a CP. Valid values are:

Sets the Ethernet IP address, Ethernet subnet mask, gateway IP address,

and host name of CP0.

Sets the Ethernet IP address, Ethernet subnet mask, gateway IP address,

and host name of CP1.

-chassis

Specifies the managed entity as the chassis.

Examples

Command line examples

To configure an IPv6 address and prefix on a standalone platform:

switch:admin>

ipaddrset -ipv6

add fec0:60:69bc:60:260:69ff:fed0:107/64

To configure an IPv6 address and prefix on a single CP of a chassis:

switch:admin>

ipaddrset -cp 0 -ipv6

add 1080::8:800:200C:417A/64

To delete any existing IPv6 address and prefix on CP0 on an enterprise-class platform:

switch:admin>

ipaddrset cp 0 -ipv6

delete

To configure a local IPv4 Ethernet address on a Brocade FC4-16E in a chassis (prefix required):

switch:admin>

ipaddrset -slot 1 -eth0

add 10.12.34.123/24

To configure a local IPv4 Ethernet address on an AP7600 with a hidden BP: