Dell POWEREDGE M1000E - Manual (Page 200)

168 Fabric OS Command Reference
53-1001764-02
cryptoCfg
2
• For each LUN:
- LUN number: numeric identifier
- LUN type: disk, tape drive, tape medium changer, tape attached medium changer,
offline/unknown, or unsupported/other
- LUN status: numeric value
- Encryption mode: encrypt or cleartext
- Encryption format: native or DF compatible
- Tape policy type: pool-based or LUN-based
- Encrypt existing data: disabled or enabled
- Rekey: disabled or enabled
- Key ID state: Read, Write, or Key ID not applicable
- Key life (in days): numeric value
- Volume/pool label: user-defined label
- Rekey status: numeric value
If rekey- or tape sessions are in progress, the command shows:
• Number of rekey sessions in progress: numeric value
• For each rekey session the display includes:
- Rekey session number: numeric value
- Percent completion: numeric value
- Rekey state: Read or Write phase
- Tape volume/pool Label: user-defined label
- Tape state: mounted or unmounted
- Tape policy configuration details:
• Tape pool or tape
• Encryption or Cleartext
• Key life span in days
• Encryption Algorithm
• Compression Algorithm
• Number of Tape sessions in progress: numeric value
• For each Tape session the display includes:
- Tape Session Number: numeric value
- Number of uncompressed blocks: numeric value
- Number of compressed blocks: numeric value
- Number of uncompressed bytes: numeric value
- Number of compressed bytes: numeric value
Use the --show -rekey command to display all rekey sessions in progress on the current node or
for a specified container. The display includes the following information:
• Number of rekey sessions in progress: numeric value
• For each rekey session, the display includes:
- Container name: user-define label