Dell POWEREDGE M1000E - Manual (Page 728)

696 Fabric OS Command Reference
53-1001764-02
portCmd
2
-pattern pattern
Specifies the test data pattern for the payload as one of the following values:
0 No pattern is specified. TPerf applies whatever is already set or in
memory. This is the default value.
1 All zeros
2 All ones
3 Incrementing byte
4 Random
5 Jitter
-size pdu_size Specifies the PDU size to use (not including headers). The valid range is
between 1k and 16k. The default is equivalent to the maximum segment size
(MSS). This is the maximum size if the -random option is specified.
-interval interval
Specifies the interval at which the statistics display is refreshed, in seconds.
The default is 30 seconds.
Examples To verify if packets can be sent to the destination IP address with maximum wait_time specified:
switch:admin>
portcmd --ping 12/ge0 -s 2007:7:30:32:227:138:10:120 -d \
2007:7:30:32:227:77:0:60 -w 29000
Pinging 2007:7:30:32:227:77:0:60 from ip interface 2007:7:30:32:227:138:10:120
on 12/ge0 with 64
bytes of data
Reply from 2007:7:30:32:227:77:0:60: bytes=64 rtt=0ms ttl=255
Reply from 2007:7:30:32:227:77:0:60: bytes=64 rtt=1ms ttl=255
Reply from 2007:7:30:32:227:77:0:60: bytes=64 rtt=0ms ttl=255
Reply from 2007:7:30:32:227:77:0:60: bytes=64 rtt=0ms ttl=255
Ping Statistics for 2007:7:30:32:227:77:0:60:
Packets: Sent = 4, Received = 4, Loss = 0 ( 0 percent loss)
Min RTT = 0ms, Max RTT = 1ms Average = 0ms
To trace the IP router hops used to reach the remote (with packet size specified):
switch:admin> portcmd --traceroute 12/ge0 -s 2007:7:30:32:227:138:10:120 -d \
2007:7:30:32:227:77:0:60 -z 1452
Traceroute to 2007:7:30:32:227:77:0:60 from IP interface
2007:7:30:32:227:138:10:120 on 12/0, 30
hops max
1 1 ms 0 ms 0 ms
Traceroute complete.
To verify if packets can be sent to the destination IP address using VLAN tagging with the -c option.
switch:admin>
portcmd --ping 8/ge0 –s 192.168.10.1 –d 192.168.20.1 –v 10 –c 3
To trace the IP router hops used to reach the remote host using VLAN tagging with the -c option.
switch:admin>
portcmd --traceroute 8/ge0 –s 192.168.10.1 –d 192.168.20.1 –v 10