Fluke Networks CertiFiber Pro Users Manual - Manual (Page 78)

Versiv Cabling Certification Product Family
Technical Reference Handbook
56
Automatic Increment Function for Cable IDs
Each time you save a result, the tester automatically saves the
result with the next ID in the set. It is not necessary for the IDs in a
set to be sequential. For example, an ID set that you make with
LinkWare software can have these non-sequential IDs:
B-1A
B-1B
RFS-A
RFS-B
CAM1-A
CAM1-B
After you save results for all IDs in a set, the auto increment
function does not operate. You must manually enter an ID each
time you save a result, unless you select a different ID set.
If you enter an ID when you save a test, and the ID is not in the
sequence of the set, the tester uses that ID, then goes back to the
next ID in the set.
Auto Save Function
The Auto Save function automatically saves results after each
test. This function decreases the time necessary to do a job.
To turn the Auto Save function on or off
1 On the home screen, tap the Next ID panel.
2 On the CHANGE ID screen, tap the On/Off control next to
Auto Save.
If Auto Save is on and the test passed, the tester saves the results
with the next available ID in the set.